Wet Differential Pressure, Conduit

Conduit adapter design
0 to 10~500 PSID
Revolutionary design eliminates plumbing
LCD display (PSID or kPa jumper selectable)
Dual 0-5/10VDC and 4-20mA outputs

The PW Conduit Wet-Wet series remote sensors are installed directly into the pipe and electrical connection is made between the PWC remote sensors and PW transmitter via 4-conductor shielded cable run through conduit. This dramatically reduces labor cost by eliminating plumbing/piping to a traditional transducer. Startup time is reduced since purging air out of the lines is not necessary. Traditional plumbed bypass assemblies are no longer required. Choose between the PW10 and PW20 model based on your anticipated PSID range.

Product improvement is a continuing process at Senva. The following products have been discontinued.

Click here to view improved products.

Product
PW10 Wet transducer - LOW Conduit Connection
PW20 Wet transducer Conduit Connection
PWC050 Pressure Sensor, 50PSI, Conduit Cable Connection
PWC100 Pressure Sensor, 100PSI, Conduit Cable Connection
PWC250 Pressure Sensor, 250PSI, Conduit Cable Connection
PWC500 Pressure Sensor, 500PSI, Conduit Cable Connection
PWSNB PRESSURE SNUBBER, 5000 PSI, WATER/LIGHT OIL